Sys Server Port Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
where
[show]
<sec>
[cancel]
This command restarts the system.
The following example shows the administrator at IP address 172.23.19.11 ordering a reboot
to occur after 1200 seconds, displaying the reboot
.
reboot
ras> sys reboot 1200
telnet-1(172.23.19.11) has initiated reboot, system reboot in 1200 seconds!
ras> sys reboot show
issued by
-------------------------- -------------- ------------------------
telnet-1(172.23.19.11)
ras> sys reboot cancel
telnet-1(172.23.19.11) has cancelled system reboot!

29.3.27 sys server port Command

Syntax:
sys server port telnet|ftp|web|snmp|ssh <port>
This command changes the port for a service on the MSC.
The following example sets the MSC to use port 24 for Telnet sessions.
ras> sys server port telnet 24
29.3.28 sys server disable Command
Syntax:
sys server enable telnet|ftp|web|snmp|ssh
This command turns off access for a service on the MSC.
502
= Displays the reboot schedule.
= The number of seconds (1~2147483647) before the system
reboots. If there is no time specified, the system reboots
immediately.
= Aborts the scheduled system rebooting.
remaining time issue time
1196 Wed Jun
schedule and then canceling the
8 15:26:54 2005
Chapter 29 sys Commands