Chapter 28 Switch Commands - ZyXEL Communications MSC1000G User Manual

This chapter shows you how to use the
28.1 switch Commands Overview
The
switch
28.2 Commands Summary
switch
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 153 switch Commands
COMMAND
switch
bandwidth
bcastctrl
dot3ad

Chapter 28 switch Commands

switch Commands
commands configure switching functions and manage the Ethernet interfaces.
switch
disable <giga-port>
enable <giga-port>
set <giga-port>
<ingress-rate>
<egress-rate>
show
show
threshold <giga-port> <bc-
limit> <mc-limit>
<uu-limit>
disable sub|up
enable sub|up [lacp]
priority <priority> Sets the LACP system priority (0~65535).
lacp
C
H A P T E R
commands.
switch
commands. The P column on the right indicates the
DESCRIPTION
Turns off bandwidth control on the specified
port(s).
Turns on bandwidth control on the specified
port(s).
Sets the incoming or outgoing bandwidth
control for the specified port(s). 0~1000
(Mbps).
Displays the bandwidth control settings.
Displays broadcast and multicast storm
control settings.
Sets the limitations of broadcast, multicast
and unknown unicast packets, in packets
per second for each trunk port (0~262143, -
1 means no limit).
<bc-limit>
<mc-limit>
<uu-limit>
limit
Turns off link aggregation on subtending or
uplink ports.
Turns on link aggregation on subtending or
uplink ports.
MSC1000G User's Guide
2 8
= broadcast packet limit
= multicast packet limit
= unknown unicast packet
lacp turns on LACP protocol.
P
M
M
M
L
L
M
M
M
M
457