Port Pvc Usratelimit Show Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide

25.10.9 port pvc usratelimit show Command

Syntax:
port pvc usratelimit show <pvc>
This command displays upstream rate limiting settings on a PVC. The following example
shows the PVC rate settings on port 1 of the line card in slot 5.
ras> port pvc usratelimit show 5-1
pvc
-------------- ---- --------------
5-1-0/33
ras>
25.10.10 port pvc vlan Command
Syntax:
port pvc vlan <slot-port-vpi/vci> <vid> <registration> <tag>
where
<slot-port-vpi/
vci>
<vid>
<registration>
<tag>
This command adds a PVC to a VLAN or removes a PVC from a VLAN. It also sets whether
the PVC sends frames with or without a VLAN tag.
384
en rate
- 1000(kbps)
= The slot and port(s) and VPI/VCI of the PVC.
= The VLAN ID. Valid parameter range = [1 – 4094].
This must be the VLAN ID of a VLAN that is already
configured. The ports specified in this command must also be
set to the fixed status in the VLAN.
= The VLAN membership setting.
= add the PVC to the VLAN.
join
= remove the PVC from the VLAN.
leave
= The VLAN tagging setting.
= the specified port(s) accept only incoming Ethernet
tag
frames that have a VLAN tag.
= the specified port(s) accept only incoming Ethernet
untag
frames that do not have a VLAN tag.
Chapter 25 port Commands