ZyXEL Communications MSC1000G User Manual page 400

MSC1000G User's Guide
Table 142 profile Commands (continued)
COMMAND
atm
igmpfilter
400
set <profile> [lofs
<lofs>] [loss
<loss>] [lols
<lols>] [lprs
<lprs>]
[ess <ess>]
[sesl <sesl>]
[uasl <uasl>]
[ift <ift>]
show [<profile>]
delete <profile>
map <profile>
set <atmprofile>
cbr|ubr <pcr>
<cdvt>
or
<atmprofile> rt-
vbr|nrt-vbr <pcr>
<cdvt> <scr> <bt>
show [<profile>]
delete <igmpfilter>
DESCRIPTION
Creates a profile of VDSL alarm
settings.
<profile> = profile name, up to 31
characters
<lofs> = number of loss of framing
seconds, 0~900
<loss>
= number of loss of signal
seconds, 0~900
<lols> = number of loss of link
seconds, 0~900
<lprs> = number of loss of power
seconds, 0~900
<ess>
= number of error seconds,
0~900
<sesl> = number of severely errored
seconds-line, 0~900
<uasl> = number of unavailable
seconds-line, 0~900
<ift>
= init failure trap enable, 1-
enable, 0-disable
Lists the VDSL alarm profiles or a
specific profile's settings.
ATM traffic profiles allow efficient
configuration of ATM traffic settings.
Removes an unreferenced ATM traffic
profile.
Displays which ports reference this
ATM profile.
Creates a profile of ATM traffic settings.
cbr = constant cell rate
ubr = unspecified cell rate
rt-vbr = realtime variable bit rate
nrt-vbr
= non-realtime variable bit
rate
<pcr> = peak cell rate, 150~300000
<scr> = sustainable cell rate,
150~300000
<cdvt> = cell delay variation
tolerance, 0~255
<bt> = burst tolerance, 0~255
Note: <pcr>, <cdvt>, <scr> and <bt>
can be inputted '*' as default value
Note: use "*" to set <pcr>, <cdvt>,
<scr> or <bt> to the default value.
Lists the ATM traffic profiles or a
specific profile's settings.
IGMP filter profiles allow you to control
access to IGMP multicast groups.
Removes an unreferenced IGMP filter
profile.
Chapter 26 profile Commands
P
M
L
M
L
M
L
M