ZyXEL Communications MSC1000G User Manual page 103

Table 27 Alarm Descriptions (continued)
ALARM
WARM_START
MGMT_ETHER_UP
MGMT_ETHER_DOWN
ALARM_IN
SPT_TOPOLOGY_CHANG
NT_FW_UPLOAD_OK
NT_FW_UPLOAD_FAIL
LT_PLUG_IN
LT_PULL_OUT
LT_DSL_DEVICE_FAIL
LT_DSL_DEVICE_RELOAD INFO
LT_ACTIVE
LT_INACTIVE
LT_FW_UPLOAD_OK
LT_FW_UPLOAD_FAIL
LT_ENABLE
LT_DISABLE
LT_RESET
NT_SWITCH_OVER
CPU_UTIL_HIGH
System
REBOOT
CONFIG_CHANGE
CONFIG_UPLOAD_OK
CONFIG_UPLOAD_FAIL
TIME_SYNC_FAIL
ALARM_CUT_OFF
ALARM_CLEAR
LOGIN_FAIL
LOGIN_OK
ACCOUNT_ADD
ACCOUNT_DELETE
ACCOUNT_MODIFY
Chapter 6 Alarm Screens
SEVERITY MSC ALC SLC
INFO X
INFO X
MINOR X
CRITICAL X
MINOR X
INFO X
MAJOR X
INFO X
MAJOR X
CRITICAL X
X
INFO X
MAJOR X
INFO X X
MAJOR X X
INFO X
INFO X
INFO X
MAJOR X
MAJOR X
INFO X
INFO X
INFO X
MAJOR X
MINOR X
INFO X
INFO X
MINOR X
INFO X
INFO X
INFO X
INFO X
VLC DESCRIPTION
System warm-start.
The management Ethernet interface is up.
The management Ethernet interface is
down.
External alarm on input <index>.
A spanning tree topology change was
detected.
Firmware upload was successful.
Firmware upload failed.
A line card was inserted into a slot.
A line card was removed from a slot.
A DSL chipset on an ALC failed.
A DSL chipset on an ALC re-downloaded
firmware <index>.
A line card became active.
A line card became inactive.
X Firmware was successfully uploaded to a
card.
X Firmware upload to a card failed.
Line card enabled.
Line card disabled.
Line card reset.
The MSC in standby mode becomes active.
The MSC is overloading.
The system restarted.
The system configuration has changed.
Uploading of the system configuration was
successful.
Uploading of the system configuration failed.
Synchronizing the time with a timeserver
failed.
An administrator cutoff (canceled) an alarm.
An administrator cleared the alarms.
A user failed to login.
A user logged in successfully.
A user account was added.
A user account was deleted.
A user's account was modified.
MSC1000G User's Guide
103