sys sw gvrp disable
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
37.4.6
sys sw vlan1q port status
Syntax:
sys sw vlan1q port status <port>
This command shows information about the specified port's VLAN settings.
The following example shows the settings for port 1.
ES-4024> sys sw vlan1q port status 1
Port 1 VLAN Setup :
Default VLAN ID = 1
VLAN Acceptable Type = All
GVRP = DISABLE
Protocol VLAN ID:
IP : none
IPX : none
NETBIOS : none
APPLETALK : none
37.4.7
sys sw vlan1q port defaultVID
Syntax:
sys sw vlan1q port defaultVID <port> <VID>
where
<port>
<VID>
This command sets a default VLAN ID for all untagged packets that come in through the specified port.
The following example sets the default VID of port 1 to 2000.
ES-4024> sys sw vlan1q port defaultVID 1 2000
Figure 37-8 sys sw vlan1q port defaultVID Command Example
37.4.8
sys sw vlan1q port accept
Syntax:
sys sw vlan1q port accept <port> <all|tagged>
where
IEEE 802.1Q Tagged VLAN
Figure 37-7 sys sw vlan1q port status Command Example
=
A port number
=
The VLAN ID. Valid parameter range = [1 – 4094].
Dimension ES-4024 Ethernet Switch
37-5