Vlan Pvid Command; Vlan Set Command; Figure 136 Vlan Pvid Command Example - ZyXEL Communications AAM1212 User Manual

28.8.6 VLAN PVID Command

Syntax:
switch vlan pvid <portlist> <pvid>
where
<portlist>
<pvid>
This command sets a default VLAN ID for all untagged packets that come in through the
specified port.
The following example sets the default VID of port 1 to 200.

Figure 136 VLAN PVID Command Example

ras> switch vlan pvid 1 200

28.8.7 VLAN Set Command

Syntax:
switch vlan set <vid> <portlist>:<F<T|U>|X|N> [<portlist>:<F<T|U>|X|N>
...][name]
where
<vid>
<portlist>
Chapter 28 Switch Commands
= You can specify a single port <1>, all ports <*> or a list of ports
<1,3,enet1>. You can also include a range of ports
<1,5,6~10,enet1,enet2>.
= The VLAN ID. Valid parameter range = [1 – 4094].
This must be the VLAN ID of a VLAN that is already
configured. The ports specified in this command must also be
set to the fixed status in the VLAN.
= The VLAN ID [1 – 4094].
= You can specify a single port: <1>, all ports: <*>, a list of ports:
<1,3,enet1>, you can also include a range of ports:
<1,5,6~10,enet1,enet2>.
AAM1212 User's Guide
229