ZyXEL Communications MSC1000G User Manual page 271

Table 124 port Commands (continued)
COMMAND
psd
set
uscarrier
copy <source>
<destination>
disable <slot-port>
enable <slot-port>
name <slot-port>
<name>
paepvc
delete
set
show
ppvc
delete
member
Chapter 16 Commands
maximum [<slot-
port> <us-psd> <ds-
psd>]
<slot-port>
<profile> <mode>
<slot-port> <m0>
<m1>
<slot-port-vpi/vci> Removes a PAE PVC.
<slot-port-vpi/vci>
<profile> <mux>
<pvid> <priority>
[acname <acname>]
[srvcname
<srvcname>]
[hellotime
<hellotime>]
<slot>|<slot-
port>|<slot-port-
vpi/vci>
<slot-port-vpi/vci> Removes a priority-based PVC.
delete <slot-port-
vpi/vci> <vpi/vci>
MSC1000G User's Guide
DESCRIPTION
Sets/displays maximum upstream/
downstream nomial PSD values. This is for
testing purposes.
<us-psd> = Upstream PSD (-400 ~ 40 in
0.1dBm/Hz).
<ds-psd> = Downstream PSD (-400 ~ 40 in
0.1dBm/Hz).
Sets ADSL port(s) to use a profile created
by the profile adsl set
<mode> = for Annex A, gdmt, t1413, glite,
auto, adsl2, adsl2+; for Annex B, gdmt, etsi,
auto, adsl2, adsl2+
Disables upstream carrier tones from 0 to
63.
<m0>, <m1>
= carrier tones, 0~ffffffff,
'1' disables the corresponding tone.
Copies port settings from a source port to
destination ports on the same type of line
card.
Turns off a subscriber port.
Turns on a subscriber port.
Sets a name for a subscriber port.
Commands for configuring and displaying
PPPoA-to-PPPoE (PAE) PVC settings.
Configures a PVC for PAE translation.
<mux> = Encapsulation type (
vcmux
).
<acname> = Host name of the access
concentrator.
<srvcname> = Descriptive name for the
service that uses this PVC.
<hellotime> = Timeout (0-600 seconds)
for PPPoE session.
Note: Make sure the VID is not
already used for MVLAN or
TLS PVC.
Displays the PAE PVC settings for the
specified port and/or slot.
Priority PVC channel commands.
Removes a PVC channel from a PVC
group.
P
M
M
command.
M
M
M
M
M
M
M
llc or
L
M
M
271