Syslog Screen; Figure 153 Ip Setup; Table 108 Ip Setup - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide

Figure 153 IP Setup

The following table describes the labels in this screen.

Table 108 IP Setup

LABEL
Inband
IP Address
IP Mask
VID
Outband
IP Address
IP Mask
Default Gateway
Apply
Cancel

14.6 Syslog Screen

Click Sys > Unix SysLog from the navigation panel to open the following screen. The syslog
feature sends logs to an external syslog server.
244
DESCRIPTION
These fields configure in-band management settings. In-band management refers
to accessing the management interface through a network port (not the
management port).
Enter the in-band management IP address for the system in dotted decimal
notation (for example 1.2.3.4).
Enter the in-band management IP subnet mask for the system in dotted decimal
notation for example 255.255.255.0.
Enter the VLAN ID (Identifier) of the management (CPU) VLAN. You must connect
to the system through a port that is a member of the management (CPU) VLAN in
order to perform in-band management.
These fields configure out-of-band management settings. Out-of-band
management refers to accessing the management interface through a
management port.
Enter the out-of-band management IP address for the management port in dotted
decimal notation (for example 1.2.3.4).
Enter the out-of-band management IP subnet mask for the management port in
dotted decimal notation for example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 14 Sys Screens