Change Tags - Xerox workcentre 5335 series Service Manual

Change Tags

Change Tag Introduction
Important modifications to the copier are identified by a tag number which is recorded on a tag
matrix:
• The tag matrix for the IOT is molded into the inside of the Front Door.
• The tag matrix for the Finisher is a label affixed to the inside of the Finisher Front Door
This section describes all of the tags associated with the machine, as well as multinational
applicability, classification codes, and permanent or temporary modification information.
Classification Codes
A tag number may be required to identify differences between parts that cannot be inter-
changed, or differences in diagnostic, repair, installation, or adjustment procedures.
A tag number may also be required to identify the presence of optional hardware, special non-
volatile memory programming, or whether mandatory modifications have been installed. Each
tag number is given a classification code to identify the type of change that the tag has made.
The classification codes and their descriptions are listed in
Table 1 Classification Codes
Classification Code Description
M Mandatory tag.
N Tag not installed in the field.
O Optional tag.
R Repair tag.
Change Tags
There are no Change Tags currently in effect for this product.
Initial Issue
WorkCentre 5335 Family Service Documentation
Table 1.
07/2011
6-69
BUS Updated 12/2011
General Procedures & Information