Table of Contents
Advertisement
Figure 2 ESS PWB Connection
NVM loc.
Name
850-001
FDI Connection
FDI is present. Automatically recognized only when FDI is connected upon
M/C power on.
Disabling FDI-CRD function, must enter [0], turn off MC and remove the
FDI connection.
850-007
Accessory Type
Type of Cost Recovery Device connected.
This function is for UI Message.
Disabling FDI-CRD function, must enter [0], turn off MC and remove the
FDI connection.
850-009
Print Job Control
Disable / Enable controlling charge print jobs by FDI-CRD
850-010
Interrupt Function
Disable / Enable the function of Interrupt at Subtractive CRD configuration. 0 = disabled (default)
Initial Issue
WorkCentre 5335 Family Service Documentation
3.
J351
Table 1 FDI NVM Settings
Function
07/2011
6-45
BUS Updated 12/2011
c.
The Foreign Accessory connects to
d.
Switch on the power.
Go to
NVM
Read/Write. Set the locations in
the customer's wishes:
0 = disabled (default)
1 = enabled
0 = None or Foot Switch (default)
1 = Additive Mode (UI msg = Use a Valid Card)
2 = Subtractive Mode (UI msg = Use a Valid Card)
3 = Dispenser - Subtractive Mode (UI msg = Use a Valid Card)
4 = Coin-Op Kit - Subtractive Mode (UI msg = Insert Coins)
5 = Multiple connection of CopyLyzer & Dispenser - Subtractive Mode
(UI msg = Use a Valid Card)
6 = Multiple connection of CopyLyzer & Coin-Op Kit - Subtractive
Mode (UI msg = Insert Coins or Use a Valid Card)
7 = Multiple connection of Dispenser & Coin-Op Kit - Subtractive
Mode (UI msg = Insert Coins or Use a Valid Card)
0 = disabled (default)
1 = enabled
1 = enabled
NOTE: When NVM 850-016 is set to 2, this setting is prohibited to be
set to enable Interrupt.
P2
on the FDI.
Table 1
depending on the type of device and
Values
General Procedures & Information
GP 11
Advertisement
Table of Contents
