Complete The Upgrade Process (S8300 Is The Primary Controller); Check Media Modules; Enable Scheduled Maintenance; Busy Out Trunks - Avaya G700 Installation And Upgrades

5
Upgrading an Existing G700 with an S8300 — R1.x to R2.0

Complete the Upgrade Process (S8300 is the Primary Controller)

Complete the Upgrade Process
(S8300 is the Primary Controller)
Telnet to the S8300 (primary controller) and open a SAT session to complete the following procedures.

Check Media Modules

1
Type
2
Verify that the software is communicating with all media modules and that all media modules are
listed in the reports.
3
Make test telephone calls to verify that Communication Manager is working.

Enable Scheduled Maintenance

1
Type
2
Ensure that the Start Time and Stop Time fields' administration is the same as before the
upgrade.

Busy Out Trunks

1
Busy out trunks that were busied out before the upgrade (see
is the Primary Controller

Check for Translation Corruption

1
Type
If you do not get a login prompt and see the following message:
Warning: Translation corruption detected
follow the normal escalation procedure for translation corruption before continuing the upgrade.

Resolve Alarms

1
On the Maintenance Web Interface, under Alarms click
log.
2
If any alarms are listed, click Clear All.
3
Resolve new alarms since the upgrade through Communication Manager using the appropriate
maintenance book.
260
and press
list configuration all
change system-parameters maintenance
on page 221).
newterm and press Enter .
.
Enter
and press Enter .
Pre-Upgrade Tasks — If the S8300
Current Alarms
Installation and Upgrades for G700 and S8300
to examine the alarm
December 2003