Administer Network Regions - Avaya G700 Installation And Upgrades

2
Enter the name and IP addresses for the LSPs.
3
Press
F 3

Administer Network Regions

Before assigning an IP network region to a G700, you must define network region on the IP Network
Region form. After a network region is defined, you can assign it to the various network elements
(servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use the system
defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region, defined as
The procedure below uses 1 for the network region number as an example but the procedure applies for
any network region number from 1 to 250.
Define IP network region 1
CAUTION:
Defining IP network regions can be quite complex. For detailed information on the use and
administration of IP network regions, see ''Administration for Network Connectivity for
Avaya Communication Manager, 555-233-504.''
1
At the SAT prompt, type
The S8300 displays the IP Network Region screen.
IP Network Region Screen
change ip-network-region 1
Region: 1
Location:
Name:
AUDIO PARAMETERS
Codec Set: 1
UDP Port Min: 2048
UDP Port Max: 3028
DiffServ/TOS PARAMETERS
Call Control PHB Value: 34
Audio PHB Value: 46
802.1P/Q PARAMETERS
Call Control 802.1p Priority: 7
Audio 802.1p Priority: 6
H.323 IP ENDPOINTS
H.323 Link Bounce Recovery? y
Idle Traffic Interval (sec): 20
Keep-Alive Interval (sec): 5
2
If necessary, complete the fields as described in ''Administration for Network Connectivity for
Avaya Communication Manager, 555-233-504.''
NOTE:
It is strongly recommended to use the defaults in the screen. However, for the RTCP
Enabled and RSVP Enabled fields, the entry should be
Installation and Upgrades for G700 and S8300
December 2003
( ) when complete.
E NT ER
change ip-network-region 1
IP NETWORK REGION
Home Domain:
Intra-region IP-IP Direct Audio: yes
Inter-region IP-IP Direct Audio: yes
RTCP MONITOR SERVER PARAMETERS
Keep-Alive Count: 5
Installing a New G700 without an S8300
Administer Communication Manager
.
Page
IP Audio Hairpinning? y
RTCP Reporting Enabled? n
Use Default Server Parameters? y
AUDIO RESOURCE RESERVATION PARAMETERS
RSVP Enabled? n
(no).
n
.
1
1 of 19
199
4