Install A New G700 Without An S8300; Checklist 2 - Avaya G700 Installation And Upgrades

1
Roadmap and Reference
Installation Roadmap and Task Lists

Checklist 2:

Install a New G700 without an S8300

Use the following checklist to install a G700 Media Gateway with the following characteristics:
•
The G700 does not have an S8300 and is controlled by an external S8300, S8500, or S8700 Media
Server.
You will use Chapters 2 and 4 with this checklist.
For help with connecting to and logging in to the G700, see
Table 2: Install a New G700 without an S8300
Major Task
Before Going to the Customer Site
page 174
Installing Hardware for the G700
Media Gateway and S8300 Media
Server on page 69
Configure the G700
Prepare to Install Firmware on the
G700 on page 191
on page 193
38
Subtasks
on - Get planning forms
- Get the G700 serial number
- Set up TFTP server, if necessary
- Download firmware files
- On site checklist
- Unpack and check the order
- Install the G700
- Cable multiple units
- Attach ground conductors
on page 178 - Assign IP addresses to the G700 processors
- Set up IP routing for the stack
- Set up default IP route for the G700
- Check IP connections
- Set up controller list for the G700
- Configure X330 Expansion Module, if necessary
- Verify contents of the tftp directory
- Determine which firmware to install
- Install firmware on the P330 stack processor
- Install firmware on the G700 media gateway
processor
- Install firmware on the media modules
- Install firmware on other G700s in the stack or
network, if any
Connection Methods
Installation and Upgrades for G700 and S8300
in this chapter.
1 of 2
December 2003