Avaya G700 Installation And Upgrades page 179

Assign the IP address to the P330 stack processor
CAUTION:
The
command is normally used only for new installations.
1
Initialize NVRAM: type
2
Change mode to configure: type
3
At the P330-1(super)# prompt, type
4
At the P330-1(configure)# prompt, type
set interface inband
processor.<vlan> is the vlan number, usually 1, to be established on the S8300 for the G700
Media Gateways. The <ip_address> <netmask> is the assigned addresses for the P330 stack
processor.
5
Type reset and press
6
Select
Yes
All LEDs will flash. As the unit powers up, self-tests will be run. When the G700 mpg or P330
stack processor has reset, login again to continue.
7
Login at the
The prompt P330-1(super)# appears.
8
Type configure
Establish the IP Routing for the Stack
1
Type show interface inband
Processor) has the correct address.
2
Type set ip route 0.0.0.0 <default-gateway>
will find these addresses in the planning documentation.
<default-gateway> is the IP address of the customer's network gateway.
3
Press Enter
4
Type
show ip route
The route net and route host tables appear. Verify that the information is correct.
Check the serial number of the G700 Media Gateway processor
After you have configured the P330 stack processor, you will assign an IP address to the G700
Media Gateway Processor (MGP). Your first step is to check the serial number of the MGP.
1
At the P330-1(configure)# prompt, type
2
At the MG-???-1(super)# prompt, type
The system displays a list of attributes, as shown in the following example:
Installation and Upgrades for G700 and S8300
December 2003
command initializes the switch parameters to the factory defaults. This
nvram init
nvram init
configure
configure
<
vlan> <ip_address> <netmask>
Enter to reset the stack.
at the dialog box that asks if you want to continue.
Welcome to P330 menu.
to obtain the P330-1(configure)# prompt.
to verify that the Avaya P330 stack server (Layer 2 Switching
to save the destination and gateway IP addresses.
.
Installing a New G700 without an S8300
.
to assign an IP address to the P330 stack
to set the destination and gateway IP addresses. You
session mgp .
to list various attributes of the G700.
show system
4
Configure the G700
179