Avaya G700 Installation And Upgrades page 296

6
Upgrading an Existing G700 with an S8300 — R2.0 to R2.x
Upgrade the Firmware on the G700
3
At the MG-001-1(super)# prompt, type
4
Type
where <slot #> is the slot of the specific media module as identified when you performed
Determine Which Firmware to Install on the
<filename mm> the full-path name of the media module firmware file in a format such
mm712v58.fdl, and
<tftp_server_ip_address> is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP Media Module upgrade takes
approximately 5 minutes. Screen messages indicate when the transfer is complete.
5
After you have upgraded all the media modules, verify that the new versions are present. At the
MG-???-1(configure)# prompt, type
The list of software appears
Show MG List_Config
SLOT
----
V0
V1
V2
V3
V4
6
In the TYPE column, find the particular media module (v1 through v4), then check the matching
field in the FW VINTAGE column to see if it matches the planning documentation. Note that slot
V1 can contain either a media module or the S8300, which will show as Type "ICC".
7
Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP firmware
identified in the planning documentation.
8
Type
9
When the reset is finished, type
Release board (if media module was busied out)
1
When the upgrade procedure is complete, go to the SAT session and release the board:
type
2
Verify the response, Command Successfully Completed.
NOTE:
If you see the response, Board Not Inserted, this means that the media module is still
rebooting. Wait one minute and repeat the
3
Repeat the
296
copy tftp mm-image v<slot #> <filename mm> <tftp_server_ip_address>
TYPE CODE SUFFIX HW VINTAGE
------ ----- ------ ----------
G700 DAF1 A 00
ICC S8300 A 72
DCP MM712 A 2
ANA MM711 A 2
DS1 MM710 A 1
reset <module #> where <module #> is the number of the G700 in the stack.
show mm
where x is the slot number of the upgraded media module.
release board vx
command for each media module that was busied out.
release board
configure to change to the configuration mode.
G700,
show mg list_config
FW VINTAGE VOIP FW
---------- -------
230(A) 67
00 N/A
58 N/A
57 N/A
58 N/A
to verify the upgrade.
release board command.
Installation and Upgrades for G700 and S8300
December 2003