Check For Ip Connections - Avaya G700 Installation And Upgrades

3
Installing a New G700 with an S8300
Configure the G700 Media Gateway
8
Select
The prompt will change to P330-1(configure)#
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
9
When the mgp reset is complete, type
10
At the MG-???-1(super)# prompt, type
command line interface.
11
Type
Assign an IP Route for the Default Gateway
The default gateway is a router or switch that routes packets to destinations outside of the local
subnetwork.
1
At the MG-???-n(configure)# prompt, type
<default_gateway_ip_address>
gateway. <default_gateway_ip_address> is the IP address of the router or switch that is
designated to handle packets addressed to destinations outside of the local subnetwork.
2
Type
3
Repeat <~Link>step 1 for additional ip routes, if needed. Usually, only a default route is needed.
Refer to your planning document.
Assign IP Addresses to the VoIP Resources
From the G700 Media Gateway Processor command line interface, you will assign IP addresses to
the VoIP resource resident on the G700 Media Gateway and to any installed MM760 VoIP Media
Modules.
1
At the MG-???-n(configure)# prompt, type
For example:
<number> is the slot number of the VoIP media module.
on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are designated
according the slot (for example,
<ip address> is the IP address of the VoIP resource.
2
Type
Modules.
3
Type

Check for IP Connections

After you have assigned IP addresses to the P330 Stack Processor (Layer 2 Switching Processor), the
G700 Media Gateway MGP, Media Modules, and the VoIP resources, do the following procedure to
validate the IP connections.
140
Yes at the dialog box that asks if you want to continue.
show interface mgp to verify that the G700 Media Gateway has the correct IP address.
. Both <destination> and <netmask> are 0.0.0.0 for the default
show ip route mgp to view the results.
set interface voip v0 132.236.73.3
v1
show interface to display a table of all configured interfaces, including all VoIP Media
show voip v0 to display the VoIP resource on the motherboard.
NOTE:
It is not necessary to configure the VLAN, netmask, or IP routes for VoIP engines. The
media gateway parameters are applied automatically.
.
session mgp
configure to reach the configuration level of the
set ip route <destination> <netmask>
set interface voip <number> <ip address>
designates the VoIP resource resident
v0
, v2 , v3 , v4 ) in which the Media Module has been installed.
Installation and Upgrades for G700 and S8300
December 2003