Avaya G700 Installation And Upgrades page 48

1
Roadmap and Reference
Connection and Login Methods
3
Follow one of the two procedures below, depending on your operating system.
Change TCP/IP Properties and Network Settings (Windows 2000 and XP)
1
Right-click My Network Places on your desktop or under the Start menu in XP.
2
Select
Windows should have automatically detected the Ethernet card in your system and created a LAN
connection for you. More than one connection may appear.
3
Right-click the correct
4
Select
5
Select
6
Click the
7
On the General tab, select the radio button
8
Disable DNS service as follows:
9
Disable WINS Resolution as follows:
10
Click
Connection Properties dialog boxes.
11
Reboot the system if directed to do so.
After you have made these changes to your computer's network configuration information, the
Network and Dial-up Connections window shows the status of the Local Area Connection:
Change TCP/IP properties (Windows 95, 98, NT 4.0, and Millennium Edition [ME])
1
Access your computer's network information. On your desktop:
2
Select
48
to display the Network and Dial-up Connections window.
Properties
Local Area Connection
to display the Local Area Connection Properties dialog box.
Properties
Internet Protocol (TCP/IP)
button. The Internet Protocol (TCP/IP) Properties screen appears.
Properties
— IP address:
192.11.13.5
— Subnet mask: 255.255.255.252
NOTE:
Record any IP addresses, DNS settings, or WINS entries that you change. You may need
to restore them later to connect to another network.
a
Click the radio button labeled
Preferred DNS server and Alternate DNS server should both be blank.
b
Click the button at the bottom of the screen. The Advanced TCP/IP Settings
Advanced
screen appears.
c
Click the tab. Verify that no DNS server is administered (the address field should be
DNS
blank).
a
Click the WINS tab. Make sure WINS is not administered (the address field should be
blank).
b
Click . If warned about an empty primary WINS address, click
OK
twice to accept the address information and close the TCP/IP and Local Area
OK
— Enabled appears when the laptop's Ethernet cable is connected to the server.
— Disabled or unplugged appears if the NIC is not connected to anything.
— Windows 95, 98, and NT: Right-click
— Windows ME: Right-click
to display the Network dialog box.
Properties
from the list in the window.
Use the following IP address
Use the following DNS server addresses
Network Neighborhood
My Network Places .
Installation and Upgrades for G700 and S8300
. Enter the following:
. The entries for
to continue.
Yes
.
December 2003