Upgrading An Existing G700 With An S8300 — R1.X To R - Avaya G700 Installation And Upgrades

• Prepare to Install Firmware on the G700
Access the P330 Stack Processor
Verify the Contents of the tftpboot Directory
Determine Which Firmware to Install on the G700
• Install New Firmware on the G700 Media Gateway
Firmware Installation Procedures
Install New Firmware on the P330 Stack Processor
Install New Firmware on the G700 Media Gateway Processor
Install New Firmware on the Media Modules
• Administer Communication Manager
The Primary Controller is an S8300
Assign Node Names and IP Addresses for the LSPs
Administer Network Regions
Associate LSPs with Network Regions
Administer IP Interfaces
Administer the LSP Form
The Primary Controller is an S8500 or S8700
Assign Node Names and IP Addresses for the C-LANs and LSPs
Administer Network Regions
Assign LSPs to the Network Regions
Administer IP Interfaces
Administer the LSP Form
• Complete the Installation Process
5 Upgrading an Existing G700 with an S8300 -
R1.x to R2.0
System Access
• Task Summary
Before Going to the Site
On-site Preparation Tasks
S8300 Upgrade Tasks
G700 Upgrade Using the Wizards
G700 Manual Upgrade Tasks
G700 Pre-upgrade Tasks
G700 Upgrade Tasks
Post-Upgrade Tasks
Installation and Upgrades for G700 and S8300
December 2003
Contents
191
191
191
191
194
194
194
194
196
198
198
198
199
200
200
201
201
202
202
204
205
206
209
211
211
212
212
212
212
213
213
213
213
213
11