Administer The Media Gateway - Avaya G700 Installation And Upgrades

Administer the Media Gateway

To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT session.
CAUTION:
Before administering a media gateway, make sure that the gateway has been fully configured.
Add Media Gateway
1
At the SAT prompt, type
where <number> is the gateway number from 1 to n . (n is 50 for an S8300 and 250 for an S8500
or S8700).
The S8300 displays the Media Gateway screen.
Add Media Gateway Screen
change media-gateway 1
Network Region: 1
2
Complete the Name field with the hostname assigned to the G700 Media Gateway.
3
Complete the Identifier field with the serial number of the G700 Media Gateway. You can obtain
the serial number by typing the
CAUTION:
Be sure the serial number for the G700 Media Gateway you enter in this procedure matches
exactly the serial number displayed in the
sensitive, and if entered incorrectly, will prevent the S8300 Media Server from
communicating with the G700 Media Gateway.
4
Complete the Network Region field with the value supplied in the planning documentation.
5
If specifically requested by the customer or your planning documents, type
announcements
Media Gateway. V9 is a virtual slot. There is no announcement board associated with it. The
announcements for the G700 are available in the G700 firmware and are administered in the same
way as announcements on the TN2301 circuit pack used on S8500 or S8700 port networks.
If there are multiple G700 Media Gateways sharing announcements, then enable announcements
on the G700 whose trunks will receive the announcements most often.
6
Press
F3
Installation and Upgrades for G700 and S8300
December 2003
add media-gateway <number>
Number: 1
Type: g700
Name: Swainsons
Serial No: 012X06230551
Registered? n
Slot Module Type
V1:
V2:
V3:
V4:
V8:
V9:
show system
in the V9 field. This field allows you to enable announcements on the G700
( ) to save your changes.
E NT ER
Installing a New G700 with an S8300
Administer Communication Manager
MEDIA GATEWAY
IP Address: 135.9.41.150
FW Version/HW Vintage: 21.13.0 /0
MAC Address:
Encrypt Link? y
Location: 1
Controller IP Address:
Site Data:
Name
command at the MGP command line.
command. The serial number is case-
show system
3
Page 1 of 1
gateway-
161