Avaya G700 Installation And Upgrades page 138

3
Installing a New G700 with an S8300
Configure the G700 Media Gateway
4
At the P330-1(configure)# prompt, type
set interface inband
processor.<vlan> is the vlan number, usually 1, to be established on the S8300 for the G700
Media Gateways. The <ip_address> <netmask> is the assigned addresses for the P330 stack
processor.
5
Type reset and press
6
Select
All LEDs will flash. As the unit powers up, self-tests will be run. When the G700 mpg or P330
stack processor has reset, login again to continue.
7
Login at the
The prompt P330-1(super)# appears.
8
Type
Establish the IP Routing for the Stack
1
Type
Processor) has the correct address.
2
Type
will find these addresses in the planning documentation.
<default-gateway> is the IP address of the customer's network gateway.
3
Press
4
Type
The route net and route host tables appear. Verify that the information is correct.
Check the serial number of the G700 Media Gateway processor
After you have configured the P330 stack processor, you will assign an IP address to the G700
Media Gateway Processor (MGP). Your first step is to check the serial number of the MGP.
1
At the P330-1(configure)# prompt, type
2
At the MG-???-1(super)# prompt, type
The system displays a list of attributes, as shown in the following example:
138
<
vlan> <ip_address> <netmask>
Enter to reset the stack.
at the dialog box that asks if you want to continue.
Yes
Welcome to P330 menu.
configure to obtain the P330-1(configure)# prompt.
show interface inband to verify that the Avaya P330 stack server (Layer 2 Switching
set ip route 0.0.0.0 <default-gateway>
to save the destination and gateway IP addresses.
Enter
show ip route .
to assign an IP address to the P330 stack
to set the destination and gateway IP addresses. You
session mgp .
to list various attributes of the G700.
show system
Installation and Upgrades for G700 and S8300
December 2003