Open The Replace Variable W/ Productname Sat Screens; Log In To The P330 Stack Processor With A Direct Connection To The Services Port - Avaya G700 Installation And Upgrades

1
Roadmap and Reference
Connection and Login Methods
Open the Replace variable w/ ProductName
SAT Screens
To run SAT:
1
If you already have a valid telnet session in progress, access the SAT program by typing sat or
dsat at the telnet prompt.
Or, to open SAT directly from your laptop,
click Start > Run and type telnet 192.11.13.6 5023 and press Enter.
2
Log in to the Replace variable w/ ProductName as
Enter your login confirmation information as prompted:
3
Enter your terminal type. Accept the default value, or enter the appropriate type for your
computer. For example, you may use type
Windows 98. For Windows 2000, use
The system displays the SAT interface.
4
Enter SAT commands as appropriate.
Log in to the P330 stack Processor with a
Direct Connection to the Services Port
1
With a direct connection to the S8300 services port, telnet to the S8300 IP address:
Type
2
Login as craft or cust.
3
Telnet to the P330 stack master stack processor.
Type
master processor on the customer's LAN.
4
Login at the Welcome to Avaya P330 screen.
Login:
Password:
You are now logged-in at the Supervisor level. The prompt appears as
P330-1(super)#
62
— Password prompt. Type your password in the Password field, and click Login or press
Enter again.
— ASG challenge. If the login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press
NOTE:
If you are upgrading an S8300/G700 remotely, connect to the customer LAN and telnet to
the IP address of the P330 stack master (that is, the P330 stack processor running as the
stack master). The IP address is the address assigned on the customer LAN, not
192.11.13.6.
telnet 192.11.13.6 .
telnet <xxx.xxx.xxx.xxx>
xxx from the planning documentation
xxx from the planning documentation
NOTE:
To check the syntax of a command in the command line interface, type as much of the
command as you know followed by
> set help
or
craft dadmin
ntt , a terminal type available for Windows NT4.0 or
.
w2ktt
, where
<xxx.xxx.xxx.xxx>
. For example:
help
Installation and Upgrades for G700 and S8300
.
Enter .
is the IP address of the P330 stack
P330-1(super)#
December 2003
.