4
Installing a New G700 without an S8300
Administer Communication Manager
Administer Communication Manager
Perform one of the two administration procedures in this section:
•
When the
•
When the
The Primary Controller is an S8300
This document covers only the administration of Communication Manager required for the G700 Media
Gateway to communicate with the primary controller over a customer's network. For the majority of
administration required, see ''Administrator's Guide to Avaya Communication Manager, 555-233-506,''
or ''Administration for Network Connectivity for Avaya Communication Manager, 555-233-504.''
In this section, you will use the SAT interface to:
•
Assign Node Names for LSPs
•
Define the IP Network Region
•
Add a Media Gateway.
Reset the System
1
Telnet to the S8300, log in, and open a SAT session (type
2
At the SAT prompt, type
The system reboots.
3
After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assign Node Names and IP Addresses for the
LSPs
If the S8300 network configuration includes LSPs, they must be specifiied on the Node Names form.
Assign node names
1
At the S8300 SAT prompt, type
Example Node Names Screen
198
The Primary Controller is an
The Primary Controller is an S8500 or S8700
CAUTION:
Before continuing, be sure you have saved translations in Communication Manager.
reset system 4
change node-names ip
Name
IP Address
default_________
0__.0__.0__.0__
node-10-lsp
192.168.1 _.50_
node-11-lsp
192.168.1 _.51_
__________
___.___.___.
__________
___.___.___.
__________
___.___.___.
S8300, or
sat
change node-names ip
to open the Node Names screen.
IP NODE NAMES
Name
_______________
_______________
_______________
_
_______________
_
_______________
_
_______________
Installation and Upgrades for G700 and S8300
or
).
dsat
Page 1 of 1
IP Address
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
December 2003