Avaya G700 Installation And Upgrades page 228

Hide thumbs Also See for G700:
Table of Contents

Advertisement

5
Upgrading an Existing G700 with an S8300 — R1.x to R2.0
Upgrade the S8300
Install the pre-upgrade update (patch)
1
Use Telnet to access the media server.
2
Type
3
At the prompt, type
The S8300 displays a list of files in the ftp directory.
4
Verify that the directory contains the *.tar.gz file you have uploaded.
5
Type
file. (For example,
6
Type
software file was installed.
7
Type
(For example,
Press
The media server goes through a software reset system 4. You must wait until the restart/reset has
completed before entering additional commands. The reset should take 1–2 minutes (or longer if
messaging is enabled).
8
Type
software file was applied.
9
Before proceeding, type
except
67/67 UP
NOTE:
The number of processes (65/65) may vary depending on the configuration. For a normal
state, the second number should not be greater than the first number. For example, the
numbers 64/65 UP would indicate that a process did not come up and should be
investigated before proceeding.
10
Close the browser.
228
a
Click
Start > Run
to open the Run dialog box.
b
Type
telnet 192.11.13.6
c
Log in as craft.
and press
cd /var/home/ftp
ls -ltr
and press
sudo patch_install patch.tar.gz
03.0.526.5-1003.tar.gz
again and press
patch_show
, where
sudo patch_apply patch
. Do not use the *.tar.gz extension at the end of the file name).
03.0.526.5-1003
Enter
.
again and press
patch_show
statapp -c
shows UP.
dupmgr
Communication Manger
. To stop the continual refresh of the
and press
.
Enter
to access the ftp directory.
Enter
Enter
to list files in the ftp directory.
, where
is the release or issue number of the update
patch
). Press
Enter
.
to list Communication Manager files to verify the new
Enter
is the release or issue number of the update file.
patch
to list Communication Manager files to verify the new
Enter
to view the status of the processes. Make sure everything
should show
command, type
statapp
Installation and Upgrades for G700 and S8300
or, if IA770 is installed,
65/65 UP
.
Ctrl-C
December 2003

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8300

Table of Contents