Administer The Lsp Form - Avaya G700 Installation And Upgrades

3
Installing a New G700 with an S8300
Administer Communication Manager
Field
Enable Ethernet
Port?
Network Region
VLAN
Number of CLAN
Sockets Before
Warning
3
Close the screen.

Administer the LSP Form

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable the LSPs
to get translations updates from the primary controller. Once the LSPs are successfully entered on the
LSP form, their status can be viewed with the
Add LSP names to the LSP form
1
At the SAT prompt, type
LSP Screen
change lsp
Number NAME
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2
Enter the node name for each LSP supported by the primary controller and submit the form.
160
The Ethernet port must be enabled (y) before it can be used. The port
must be disabled (n) before changes can be made to its attributes on
this screen.
The region number for this IP interface.
The VLAN number assigned to the C-LAN, if any.
The threshold for the number of sockets used by this C-LAN that
triggers a warning message to be sent to the error log.
NOTE:
The LSP node names must be administered on the node-names-ip form before they can be
entered on the LSP form.
change lsp
LOCAL SURVIVABLE PROCESSOR
IP Address
node-10-LSP_ 192.168.1.50
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
Conditions/Comments
display lsp command.
to open the LSP form.
Page
Service Translations
State?
in-service 14:21 5/4/2003
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
Installation and Upgrades for G700 and S8300
2 of 2
1 of 16
Updated
December 2003