Avaya G700 Installation And Upgrades page 188

4
Installing a New G700 without an S8300
Configure the G700
The following table describes the possible optional controllers for an S8300 and S8700 primary
controller:
Primary Server
S8300
S8500 or S8700
For an S8500 or S8700 primary controller, the last three IP addresses in the list can be either the
addresses of C-LANS (which are connected to the same S8500 or pair of S8700s that act as
primary controllers) or addresses of LSPs. If you enter a combination of both, you must list C-
LANs first and the LSPs last, after the C-LANs.
2
Type
processor.
A system prompt asks to confirm the reset.
3
Select
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
The system ultimately returns you to the P330-1 (configure) prompt.
At the P330-1(configure)# prompt, type
At the MG-001-1(super)# prompt, type
Because the G700 media gateway has registered with its primary controller, the prompt
name has changed; for example, to MG-001-1.
Type
For example:
188
Controller IP Addresses
IP address of the S8300 primary controller.
First:
one, two, or three IP addresses of S8300s configured as
Next three:
LSPs.
IP address of the C-LAN for the S8500 or S8700 primary
First:
controller.
one, two, or three IP addresses of alternate C-LANs and/or
Next three:
LSPs.
reset mgp at the MG-???-n(configure)# prompt to reset the G700 Media Gateway
Yes at the dialog box that asks if you want to continue.
NOTE:
show mgc to display the list of available servers and their IP addresses.
session mgp .
to change to the configuration mode.
configure
Installation and Upgrades for G700 and S8300
December 2003