Determine Which Firmware To Install On The G700 - Avaya G700 Installation And Upgrades

6
Upgrading an Existing G700 with an S8300 — R2.0 to R2.x
Upgrade the Firmware on the G700
Determine Which Firmware to Install on the
G700
Conduct the following procedure to compare software versions running on the G700 processors and
media modules with the versions in you planning documents. If the versions do not match, new firmware
for those components is necessary.
Determine if new firmware for the P330 stack processor is necessary.
1
At either the P330-1(super)# or P330-1(configure)# prompt, type
The system displays the list of software.
Directory List for P300 Processor
M# file
-- ----
1 module-config
1 stack-config
1 EW_Archive
1 Booter_Image
2
Check the version number (ver num) of the EW_Archive file to see if it matches the Release
Letter. If not, you must upgrade the P330 stack processor.
3
Type
The system displays the list of software.
Show Image Version List for P330 Processor
Mod
------
3
3
4
Check the version number of the stack software image file in Band B to see if it matches the your
planning document. If not, you must upgrade the P330 stack processor.
Determine if new firmware is required for the MGP, VoIP Module, and installed media
modules.
1
Type
2
At the MG-001-1(super)# prompt, type
The system displays the list of software.
292
ver num file type
------- ----------
N/A Running Conf
N/A Running Conf
3.8.6 SW Web Image
3.2.5 SW BootImage
show image version
Module-Type
-----------
Avaya G700 Media Gateway
Avaya G700 Media Gateway
session mgp
dir
file location file description
------------- ----------------
Ram Module Configuration
Ram Stack Configuration
NV-Ram WEB Download
NV-Ram Booter Image
show mg list_config
Installation and Upgrades for G700 and S8300
.
Bank Version
---- -------
A 0.0.0
B 3.9.0
December 2003