Set The Lsp Transition Points - Avaya G700 Installation And Upgrades

Type show mgc
For example:
Show Call Controller Status Screen
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered
Active Controller
H248 Link Status
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST
--------------------
135.9.71.95
- Not Available --
- Not Available --
- Not Available --
The Gateway will have registered with the primary controller, if present. If the primary controller
is running and has been administered properly, the Registered field says
Status says
Status says

Set the LSP Transition Points

You must set the time that the G700 searches, in the event of a network problem, for primary controllers
(for example, additional CLAN connections) with which to register. After this search time has elapsed,
the G700 will search for an LSP with which to register. You must also set the total time the G700 searches
for either a primary controller and an LSP, after which the G700 resets. And finally, you must define how
many primary controllers, from 1 to 4, are in the controller list you just defined.
1
At the MG-001-1(configure)# prompt, type
where <search-time> is the time in minutes that the G700 searches for a primary controller
before looking for an LSP. The range is from
2
At the MG-001-1(configure)# prompt, type
where <search-time> is the time in minutes that the G700 searches for both primary controllers
or LSPs. The range is from
3
At the MG-001-1(configure)# prompt, type
<#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the primary
controller is an S8500 or S8700, the range is from
<#_of_primary> must be
Installation and Upgrades for G700 and S8300
December 2003
to display the list of available servers and their IP addresses.
: YES
: 135.9.71.95
: UP
DHCP SPECIFIED MGC HOST
-----------------------
-- Not Available --
-- Not Available --
-- Not Available --
-- Not Available --
. If the controller is not running, the Registered field says
UP
DOWN .
to .
1 60
.
1
Installing a New G700 with an S8300
Configure the G700 Media Gateway
set mgp reset-times primary-search <search-time>
1 to 60 .
set mgp reset-times total-search <search-time>
set mgp reset-times transition-point
to If the primary controller is an S8300,
1 4.
YES and the H248 Link
and the H248 Link
NO
143
3