Avaya G700 Installation And Upgrades page 180

4
Installing a New G700 without an S8300
Configure the G700
Show System List for G700 Media Gateway
MG-001-1(super)# show sys
Uptime(d,h:m:s): 1, 08:17:12
System Name
System Location: -- Empty --
System Contact : -- Empty --
MAC Address
Serial No
Model No
HW Vintage
HW Suffix
FW Vintage
Media Gateway Power Supplies
DSP Complex
MGP
Fans
Media Modules
VoIP DSP
VoIP 8260
Aux
--type q to quit or space key to continue--
MG-???-1(super)#
3
Write the serial number on your planning document. Make sure it matches the serial number
sticker on the back of the G700 Media Gateway chassis. If there is a difference, the serial number
in the displayed list is correct.You will need this later.
Assign the IP Address to the G700 Media Gateway Processor
1
At the MG-???-n(super)# prompt, type
2
Type
This procedure re initializes the G700 software back to factory defaults so new IP addresses can
be stored correctly in the software. It also clears all configuration and administration on the G700
Media Gateway.
The system prompts you to verify that you want to erase the configuration.
3
Answer the prompt by typing
The G700 Media Gateway re initializes.
4
At the P330-1(configure)# prompt, type
5
At the MG-???-1(super)# prompt, type configure to change to configuration mode.
6
Type
Media Gateway. <vlan> is the vlan to be established on the customer's local network. This is
usually
7
At the MG-???-n(configure)# prompt, type
A system prompt asks to confirm the reset.
180
: -- Empty --
: 00-04-0D-02-04-EF
: 02DR07428721
: G700
: 00
: A
: 230
VOLTAGE(V) ACTUAL(V)
---------- ---------- ----------
3.4
5.1
1.2
-48.0
1.6
2.5
-48.0
to recondition the processor.
nvram init
y (es).
set interface mgp <vlan> <ip_address> <netmask>
1 . The <ip_address> <netmask> is the assigned addresses for the G700 Media Gateway.
CAUTION:
If this G700 contains an S8300 configured as an LSP, use the VLAN administered on the
primary controller.
STATUS
3.359 OK
5.000 OK
0.000 OK
-47.259 OK
1.570 OK
2.470 OK
0.000 OK
to change to configuration mode.
configure
session mgp .
to assign an IP address to the G700
.
reset mgp
Installation and Upgrades for G700 and S8300
December 2003