Check Media Modules - Avaya G700 Installation And Upgrades

6
Upgrading an Existing G700 with an S8300 — R2.0 to R2.x
Complete the Upgrade Process (S8300 is the Primary Controller)
Complete the Upgrade Process
(S8300 is the Primary Controller)
Telnet to the S8300 (primary controller) and open a SAT session to complete the following procedures.

Check Media Modules

1
Type
2
Verify that the software is communicating with all media modules and that all media modules are
listed in the reports.
3
Make test telephone calls to verify that Communication Manager is working.
Enable Scheduled Maintenance
1
Type
2
Ensure that the Start Time and Stop Time fields' administration is the same as before the
upgrade.
Busy Out Trunks
1
Busy out trunks that were busied out before the upgrade (see
Check for Translation Corruption
1
Type
If you do not get a login prompt and see the following message:
Warning: Translation corruption detected
follow the normal escalation procedure for translation corruption before continuing the upgrade.
Resolve Alarms
1
On the Maintenance Web Interface, under Alarms click
log.
2
If any alarms are listed, click Clear All.
3
Resolve new alarms since the upgrade through Communication Manager using the appropriate
maintenance book.
Re-enable Alarm Origination
1
Telnet to the S8300 and log on.
2
At the command prompt, type
298
and press
list configuration all
change system-parameters maintenance
and press .
newterm Enter
almenable -d b -s y
.
Enter
and press Enter .
Record All
Current Alarms
, where
Installation and Upgrades for G700 and S8300
Busyouts).
to examine the alarm
December 2003