Avaya G700 Installation And Upgrades page 208

4
Installing a New G700 without an S8300
Administer Communication Manager
Media Gateway Screen (After Registration with Primary Controller)
change media-gateway 1
Network Region: 1
The media modules installed in the G700 are listed next to their slot numbers.
To verify that a G700 Media Gateway has been successfully added:
Verify Changes
1
At the SAT prompt, type
List Media-Gateway Screen
list media-gateway
Number
1
2
2
Verify that the G700 Media Gateway has registered.
The
should become unregistered, the
the G700 Media Gateway. If the G700 has never been registered, the IP Address field will be
blank.
If the G700 fails to register, two common causes might be:
208
MEDIA GATEWAY
Number: 1
Type: g700
Name: Swainsons
Serial No: 012X06230551
Registered? y
Slot Module Type
V1: S8300
V2: MM712
V3: MM711
V4: MM710
V8:
V9:
list media-gateway
MEDIA-GATEWAY REPORT
Name Serial No/
FW Ver/HW Vint
LabA 01DR07128730
21 .13 .0
Data MG2 02DR01130356
11 .2
in the registered field signifies that the G700 Media Gateway has registered. If the G700
y
— The serial number added as the identifier for the G700 is wrong. To check, log back into
the G700 gateway and type show system. Check the serial number that appears.
— There is no IP connection between the G700 and the S8300. To check, type
and then ping mgp <controller_address>
IP Address: 135.9.41.150
FW Version/HW Vintage: 21.13.0 /0
MAC Address: 00:04:0d:02:06:ca
Encrypt Link? y
Location: 1
Controller IP Address: 135.9.41.146
Site Data:
Name
ICC MM
DCP MM
ANA MM
T1/E1 MM
.
IP Address/
Cntrl IP Addr
135.177.49.57
/0 135.177.49.59
135.177.49.90
.0 /0 135.177.49.40
y will become an n , but the IP address will remain assigned to
.
Installation and Upgrades for G700 and S8300
Page 1 of 1
Type NetRgn Reg?
g700 1 y
g350 1 n
show mgc
December 2003