Avaya G700 Installation And Upgrades page 313

5
After you have upgraded all the media modules, verify that the new versions are present. At the
MG-???-1(configure)# prompt, type
The list of software appears
Show MG List_Config
SLOT TYPE
---- ------ -----
V0 G700
V1 ICC
V2 DCP
V3 ANA
V4 DS1
6
In the TYPE column, find the particular media module (v1 through v4), then check the matching
field in the FW VINTAGE column to see if it matches the planning documentation. Note that slot
V1 can contain either a media module or the S8300, which will show as Type "ICC".
7
Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP firmware
identified in the planning documentation.
8
Type
reset <module #>
9
When the reset is finished, type
Release board (if media module was busied out)
1
When the upgrade procedure is complete, go to the SAT session and release the board:
type
release board vx
2
Verify the response, Command Successfully Completed.
NOTE:
If you see the response, Board Not Inserted, this means that the media module is still
rebooting. Wait one minute and repeat the
3
Repeat the
This completes the firmware upgrade procedures.
Installation and Upgrades for G700 and S8300
December 2003
show mg list_config
CODE SUFFIX HW VINTAGE
------ ----------
DAF1 A 00
S8300 A 72
MM712 A 2
MM711 A 2
MM710 A 1
where <module #> is the number of the G700 in the stack.
show mm
where x is the slot number of the upgraded media module.
release board command for each media module that was busied out.
Upgrading an Existing G700 without an S8300
Install New Firmware on the G700 Media Gateway
FW VINTAGE VOIP FW
---------- -------
230(A) 67
00 N/A
58 N/A
57 N/A
58 N/A
to verify the upgrade.
command.
release board
7
313