6
Upgrading an Existing G700 with an S8300 — R2.0 to R2.x
Upgrade the Firmware on the G700
<Module#> is the number, 1 through 10, of the media gateway in the stack. If there is only one
G700 Media Gateway, the number is
2
To verify that the download was successful when the prompt returns:
3
Type
Install New Firmware on the G700 Media
Gateway Processor
Install MGP firmware
1
At the P330-1(configure)# prompt, type
processor.
2
Type
the prompt to MG-???-1(configure)#.
3
At the MG-???-1(configure)# prompt, type
partition (bank) is in the Active Now column. You will update the bank that is not listed as Active
Now. The system displays the following screen:
Example: Show mgp bootimage
FLASH MEMORY
Bank A
Bank B
ACTIVE NOW
Bank B
4
At the MG-???-1(configure)# prompt, type
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700, where
<bank> is the bank that is not Active Now (Bank A in the example).
<filename> is the full path name of the mgp firmware image file, which begins with mgp and will
be similar to the name mgp_8_0.bin.
<tftp_server_ip_address> is the IP address of the S8300. See the following example:
copy tftp mgp-image a mgp_8_0.bin 195.123.49.54.
The screen will show the progress.
5
Type
step.
294
— type
show image version <module #>
column for Bank B.
— type
and check the version number in the ver num column for the
dir <module #>
EW_Archive file.
reset <module #>
at the MG-???-1(super)# prompt to enter configuration mode, which will change
configure
IMAGE VERSION
109
210
ACTIVE AFTER REBOOT
Bank B
set mgp bootimage <bank>
.
1
and check the version number in the Version
to reach the G700 Media Gateway
session mgp
show mgp bootimage
where <bank> is the same letter you entered in the previous
Installation and Upgrades for G700 and S8300
to determine which disk
December 2003