Administer Network Regions - Avaya G700 Installation And Upgrades

3
Installing a New G700 with an S8300
Administer Communication Manager
Example Node Names Screen
2
Enter the name and IP addresses for the LSPs.
3
Press

Administer Network Regions

Before assigning an IP network region to a G700, you must define network region on the IP Network
Region form. After a network region is defined, you can assign it to the various network elements
(servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use the system
defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region, defined as
The procedure below uses 1 for the network region number as an example but the procedure applies for
any network region number from 1 to 250.
Define IP network region 1
1
At the SAT prompt, type
The S8300 displays the IP Network Region screen.
152
change node-names ip
Name IP Address
default_________ 0__.0__.0__.0__
node-10-lsp 192.168.1 _.50_
node-11-lsp 192.168.1 _.51_
__________ ___.___.___.
__________ ___.___.___.
__________ ___.___.___.
( ) when complete.
F 3 E NT ER
CAUTION:
Defining IP network regions can be quite complex. For detailed information on the use and
administration of IP network regions, see ''Administration for Network Connectivity for
Avaya Communication Manager, 555-233-504.''
change ip-network-region 1
IP NODE NAMES
Name
_______________
_______________
_______________
_ _______________
_ _______________
_ _______________
.
Installation and Upgrades for G700 and S8300
Page 1 of 1
IP Address
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
1 .
December 2003