Avaya G700 Installation And Upgrades page 311

3
At the MG-???-1(configure)# prompt, type
partition (bank) is in the Active Now column. You will update the bank that is not listed as Active
Now. The system displays the following screen:
Example: Show mgp bootimage
FLASH MEMORY
Bank A
Bank B
ACTIVE NOW
Bank B
4
At the MG-???-1(configure)# prompt, type
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700, where
<bank> is the bank that is not Active Now (Bank A in the example).
<filename> is the full path name of the mgp firmware image file, which begins with mgp and will
be similar to the name mgp_8_0.bin.
<tftp_server_ip_address> is the IP address of the S8300. See the following example:
copy tftp mgp-image a mgp_8_0.bin 195.123.49.54.
The screen will show the progress.
5
Type
set mgp bootimage <bank>
step.
6
At the MG-???-1(configure)# prompt, type
A system prompt asks to confirm the reset.
7
Select
Yes
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
8
When the P330-1(super)# prompt appears, type
9
At the MGP-???-1(super)# prompt, type
10
Verify that the download was successful when the prompt returns.
Type show mg list_config
Installation and Upgrades for G700 and S8300
December 2003
IMAGE VERSION
109
210
ACTIVE AFTER REBOOT
Bank B
where <bank> is the same letter you entered in the previous
at the dialog box that asks if you want to continue.
. The system displays the list of software.
Upgrading an Existing G700 without an S8300
Install New Firmware on the G700 Media Gateway
show mgp bootimage to determine which disk
.
reset mgp
session mgp.
configure .
7
311