Avaya G700 Installation And Upgrades page 182

4
Installing a New G700 without an S8300
Configure the G700
Run the ping command
1
At the MG-???-n(config)# prompt, type
where <IP_address> is the address of an S8300, S8500, or S8700 Media Server, the VoIP engine,
or any other functioning endpoint accessible on the customer's LAN. It is recommended to ping
endpoints on both the same subnet and a different subnet.
Ping results appear on the screen, similar to the following example.
Ping MGP Results
MG-???-1(configure)# ping mgp 135.122.49.55
PING 135.122.49.55: 56 data bytes
64 bytes from 135.122.49.55: icmp_seq=0. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=1. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=2. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=3. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=4. time=0. ms
----135.122.49.55 PING Statistics----
5 packets transmitted, 5 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
2
Check that the same number of packets transmitted were also received.
3
Type
functioning endpoint on the customer's LAN. Ping results appear on the screen, similar to the
following example.
Ping VoIP Results
MG-???-1(configure)# ping voip v0 135.122.49.55
----135.122.49.55 PING Statistics----
5 packets transmitted, 5 packets received, 0 packet loss
round-trip(ms) min/avg/max = 0/1/0
182
ping voip v0 <IP_address>,
ping mgp <IP_address>
where <IP_address> is the address of the G700, or any other
Installation and Upgrades for G700 and S8300
December 2003