Configure The G700; Assign The Ip Addresses Of The G700 Media Gateway Components - Avaya G700 Installation And Upgrades

4
Installing a New G700 without an S8300

Configure the G700

Configure the G700
For a new installation of a G700 Media Gateway, you must complete the following configuration tasks:
•
Assign IP addresses to the G700 processors
•
Assign IP routes for the gateway
•
Set up the controller list
Assign the IP Addresses of the G700 Media
Gateway Components
This section describes how to assign the IP addresses and IP routes to the G700 Media Gateway and its
components. The IP addresses should be available to you on the IP Addressing Planning Form. The
command arguments you will be supplying include:
vlan
IP address
netmask
destination
default gateway
Access the P330 stack processor
1
Set up a direct connection to the G700 Console (serial) port and access the P330 stack processor
using Hyperterm (or similar terminal emulation application).
2
Login as root.
178
Tip:
The Avaya Gateway Installation Wizard (GIW) performs tasks automatically in the , ,
Check for IP Connections, and
does not configure an X330 Expansion module. This task you must still perform as
described in this document.
NOTE:
The Gateway Installation Wizard (GIW) performs this task automatically.
–Virtual Local Area Network: a defined network segment that allows
users on that segment to have priority services in sharing information
with each other.
If the network is not using VLANs, the VLAN should be 1. Otherwise,
use the VLAN numbers indicated in your planning forms. The G700
Media Gateway should be assigned the same VLAN as the VLAN to
which the Ethernet ports are connected. The P330 stack processor might
or might not be assigned to the customer's network management VLAN.
–the unique identifier assigned to an entity on the customer LAN
–the subnet mask for the customer's LAN segment
–distant networks that the IP route command needs to send packets to.
Usually generalized to 0.0.0.0 for networks other than the local segment.
–the gateway the ip route command specifies to get to the distant
networks
Set the LSP Transition Points
Installation and Upgrades for G700 and S8300
sections. However, the GIW
December 2003