Avaya G700 Installation And Upgrades page 184

4
Installing a New G700 without an S8300
Configure the G700
Establish the IP Routing for the Stack
1
Type show interface inband to verify that the Avaya P330 stack server (Layer 2 Switching
Processor) has the correct address.
2
Type set ip route 0.0.0.0 <default-gateway> to specify the gateway to handle addresses
outside of the local subnet.
< default-gateway> is the IP address of the customer's default network gateway. This address
should be available in the planning documentation.
3
Press
4
Type show ip route .
The route net and route host tables appear. Verify that the information is correct.
Check the serial number of the G700 Media Gateway processor
After you have configured the P330 stack processor, you will assign an IP address to the G700
Media Gateway Processor (MGP). Your first step is to check the serial number of the MGP.
1
At the
2
At the
The system displays a list of attributes, as shown in the following example:
Show System List for G700 Media Gateway
MG-001-1(super)# show sys
Uptime(d,h:m:s): 1, 08:17:12
System Name
System Location: -- Empty --
System Contact : -- Empty --
MAC Address
Serial No
Model No
HW Vintage
HW Suffix
FW Vintage
Media Gateway Power Supplies
DSP Complex
MGP
Fans
Media Modules
VoIP DSP
VoIP 8260
Aux
--type q to quit or space key to continue--
MG-???-1(super)#
3
Write the serial number on your planning document. Make sure it matches the serial number
sticker on the back of the G700 Media Gateway chassis. If there is a difference, the serial number
in the displayed list is correct.You will need this later.
184
Enter to save the destination and gateway IP addresses.
prompt, type session mgp.
P330-1(configure)#
prompt, type show system to list various attributes of the G700.
MG-???-1(super)#
: -- Empty --
: 00-04-0D-02-04-EF
: 02DR07428721
: G700
: 00
: A
: 230
VOLTAGE(V) ACTUAL(V)
---------- ---------- ----------
3.4 3.359
5.1 5.000
1.2 0.000
-48.0 -47.259
1.6 1.570
2.5 2.470
-48.0 0.000
STATUS
OK
OK
OK
OK
OK
OK
OK
Installation and Upgrades for G700 and S8300
December 2003