Connection Methods; Connect Laptop To Services Port Of S8300; Connect Laptop To The G700 Serial Port - Avaya G700 Installation And Upgrades

Connection Methods

Connect Laptop to Services Port of S8300

To connect your laptop directly to the S8300 Media Server:
1
Make sure your laptop meets the hardware and software requirements.
2
Plug an Ethernet crossover cable (MDI to MDI-X) into the 10/100 BaseT Ethernet network
interface card (NIC) on your laptop.
— Crossover cables of various lengths are commercially available.
— See the following table for pinout connections if needed. Crossover of the transmit and
receive pairs (as shown) is required.
3
Connect the other end of the crossover cable to the Services port on the front of the S8300.
4
If your laptop is configured with the correct network settings, you can now open your Internet
browser or start a Telnet session and log in. When accessing the server from a directly connected
laptop, always type the following IP address in the browser's Address or Location field to access
the server:

Connect Laptop to the G700 Serial Port

To configure a G700 that does not have an S8300, you may need to set up a direct connection from your
laptop's serial port to the G700 Console (serial) port.
To connect a laptop directly to the serial port on the G700 Media Gateway:
1
For a stacked configuration, locate the device that contains the master controller for the stack.
Check the LED panel on the upper left of each G700 or P330 device in the stack as follows:
— G700 Media Gateway: a lit
— A non-G700 P330 device: a lit
Installation and Upgrades for G700 and S8300
December 2003
Crossover cable pinout chart
Pin to
S8300
Services
Port
8
7
6
5
4
3
2
1
192.11.13.6
MSTR
SYS
Connection and Login Methods
Pin to
Laptop
Connects Ethernet
to card
8
7
2
5
4
1
6
3
LED indicates that this unit is the stack master.
LED indicates that this unit is the stack master.
Roadmap and Reference
51
1