Install New Firmware On The G700; Verify The Contents Of The Tftpboot Directory; Determine Which Firmware To Install On The G700 - Avaya G700 Installation And Upgrades

Install New Firmware on the G700

This section describes the procedures to install firmware on the G700 Media Gateway processors and
media modules.

Verify the Contents of the tftpboot Directory

Before proceeding with the G700 firmware installation, you should check the tftpboot directory on the
TFTP server to make sure the firmware versions match those listed in the planning documentation.
Determine Which Firmware to Install on the
G700
Conduct the following procedure to compare software versions running on the G700 processors and
media modules with the versions in you planning documents. If the versions do not match, new firmware
for those components is necessary.
Determine if new firmware for the P330 stack processor is necessary.
1
At either the P330-1(super)# or P330-1(configure)# prompt, type
The system displays the list of software.
Directory List for P300 Processor
M# file
-- ----
1 module-config
1 stack-config
1 EW_Archive
1 Booter_Image
2
Check the version number (ver num) of the EW_Archive file to see if it matches the Release
Letter. If not, you must upgrade the P330 stack processor.
3
Type show image version
The system displays the list of software.
Show Image Version List for P330 Processor
Mod Module-Type
------ -----------
3 Avaya G700 Media Gateway
3 Avaya G700 Media Gateway
Installation and Upgrades for G700 and S8300
December 2003
ver num file type file location
------- ---------- -------------
N/A Running Conf Ram
N/A Running Conf Ram
3.8.6 SW Web Image NV-Ram
3.2.5 SW BootImage NV-Ram
Installing a New G700 with an S8300
Install New Firmware on the G700
dir .
file description
----------------
Module Configuration
Stack Configuration
WEB Download
Booter Image
Bank Version
---- -------
A 0.0.0
B 3.9.0
3
145