Install New Firmware On The Media Modules - Avaya G700 Installation And Upgrades

5
Upgrading an Existing G700 with an S8300 — R1.x to R2.0
Upgrade the Firmware on the G700
6
At the MG-???-1(configure)# prompt, type
A system prompt asks to confirm the reset.
7
Select
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
8
When the P330-1(super)# prompt appears, type
9
At the MGP-???-1(super)# prompt, type
10
Verify that the download was successful when the prompt returns.
Type
Example: Show mg list_config

Install New Firmware on the Media Modules

For upgrades of active media modules, you need to take the media modules out of service before
initiating the upgrade process. To do this, go to a SAT session on the primary controller and issue a
busyout command.
NOTE:
Skip this busyout procedure if the media modules are not in service; for example during
an initial installation.
Busyout board (for active media modules)
1
Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
2
Verify the response, Command Successfully Completed.
3
Repeat for each media module to be upgraded.
Install media module firmware
1
Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on the
G700 motherboard) (see
does not occupy a physical position like other Media Modules.
2
At the P330-1(configure)# prompt, type
254
Yes at the dialog box that asks if you want to continue.
. The system displays the list of software.
show mg list_config
SLOT TYPE CODE SUFFIX
---- ------ ----- ------
V0 G700 DAF1 A
V1 ICC S8300 A
V2 DCP MM712 A
V3 ANA MM711 A
V4 DS1 MM710 A
Determine Which Firmware to Install on the
reset mgp .
session mgp.
.
configure
HW VINTAGE FW VINTAGE
---------- ----------
00 230(A)
72 00
2 58
2 57
1 58
.
session mgp
Installation and Upgrades for G700 and S8300
VOIP FW
-------
67
N/A
N/A
N/A
N/A
G700). This VoIP module
December 2003