Identifying The Tgm550 Serial Number; Checking The Mgc List Transition Points; Pinging The Communication Manager Server - Avaya IG550 Installing And Configuring

Installing an IG550 Integrated Gateway using the Disk on Key
Tip:
After a specific user login and password have been administered on the
Tip:
TGM550, you can alternatively use the following command to log into the
TGM550 from the router interface:
request tgm login fpc <slot> user <tgm-user>
where slot is the slot number of the TGM550 and
user.

Identifying the TGM550 serial number

1. At the command line, type show system.
2. Note the serial number of the TGM550. You need the serial number later to administer the
media gateway in Communication Manager. See

Checking the MGC list transition points

1. At the TGM550 command line, type show recovery and check the transition points for
the MGC list.

Pinging the Communication Manager server

1. At the TGM550 command line prompt, type ping <ip_address>, where <ip_address>
is the IP address of the server.
Replies from the server scroll down the screen.
2. If the TGM550 does not successfully ping the server, do the following:
a. At the command line prompt, type exit.
The ssh connection drops and reverts to the Unix command line of the router.
36 Installing and Configuring the IG550 Integrated Gateway
,
is the login of the
tgm-user
Adding Media Gateways on page 150.