Setting The Lsp Transition Points - Avaya G700 Installing Manual

Media gateway and media server
Hide thumbs Also See for G700:
Table of Contents

Advertisement

Show Call Controller Status Screen
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered
Active Controller
H248 Link Status
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST
--------------------
135.9.71.95
- Not Available --
- Not Available --
- Not Available --
The Gateway will have registered with the primary controller, if present. If the primary
controller is running and has been administered properly, the Registered field says YES
and the H248 Link Status says UP. If the controller is not running, the Registered field says
NO and the H248 Link Status says DOWN.

Setting the LSP Transition Points

You must set the length of time that the G700 searches, in the event of a network problem, for
primary controllers (for example, additional CLAN connections) with which to register. After this
search time has elapsed, the G700 will search for an LSP with which to register. You must also
set the total time the G700 searches for either a primary controller and an LSP, after which the
G700 resets. And finally, you must define how many primary controllers, from 1 to 4, are in the
controller list you just defined.
To set LSP transition points
1. At the MG-001-1(configure)# prompt, type set mgp reset-times primary-search
<search-time>
where <search-time> is the time in minutes that the G700 searches for a primary
controller before looking for an LSP. The range is from 1 to 60.
2. At the MG-001-1(configure)# prompt, type set mgp reset-times total-search
<search-time>
where <search-time> is the total time in minutes that the G700 searches for both primary
controllers or LSPs. The range is from 1 to 60.
: YES
: 135.9.71.95
: UP
DHCP SPECIFIED MGC HOST
-----------------------
-- Not Available --
-- Not Available --
-- Not Available --
-- Not Available --
Configure the G700 Media Gateway
Issue 9.1 June 2006
505

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8300

Table of Contents