Using The Image Shift Feature To Reposition The Copy Image - Xerox WorkCentre series User Manual

Copy
Off applies no binding edge erase to the output.
•
• Both Pages scans both pages, the left page of the book will be scanned first. Use the arrow
buttons to specify an amount from 0 to 50mm (0 to 2") to be deleted from the center of
the book image.
• Left Page Only scans the left page only. Use the arrow buttons to specify an amount from
0 to 25mm (0 to 1") to be deleted from the right side of the page image.
• Right Page Only scans the right page only. Use the arrow buttons to specify an amount
from 0 to 25mm (0 to 1") to be deleted from the left side of the page image.
9. Select the OK button.
10. Enter the number of prints required using the numeric keypad on the control panel.
11. Press the Start button on the control panel to scan the original.
12. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
13. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
14. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Building a Copy Job with Multiple Page or Segment Settings
Using a User ID to Log In at the Device
Viewing the Progress and Details of a Job using the Job Status Menu
Specifying the Size of the Original to be Copied

Using the Image Shift Feature to Reposition the Copy Image

When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Use the Image Shift option to move the position of the image on the output page. This is useful
when the output needs to be bound as it allows you to move the image to the left or right to leave
enough room for the binding.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen.
5. Select the Layout Adjustment tab.
6. Select the Image Shift button.
User Guide
®
WorkCentre XXXX
103