Xerox WorkCentre series User Manual page 465

Print
Use the Saved Job option to store your job on the device's hard drive so that it can then be printed
on demand when required or printed from Internet Services.
Note: Your System Administrator must enable the Job Storage feature on your print driver before
you can use the Saved Job option. If you are able to update your own driver settings, this feature
can be found by opening the drivers window, right clicking the driver, selecting Printer Properties
and then the Configuration tab. Use the dropdown menu to set the Job Storage Module status in
the Installable Options section to Installed.
Use the Fax option in your print driver to send a document to a fax address. The job is sent from
your computer to the device in the same way as a print job, but instead of being printed it is then
faxed over a telephone line to the specified fax destination.
Note: To use this feature, your System Administrator must install and enable the fax option on your
device.
1. Open the document to be printed. From most applications select File, then select Print from
the file menu.
2. Enter the number of copies you want to produce. Depending on the application you are using
you may also be able to select a page range and make other print selections.
3. Select the Xerox driver from the list of print drivers available.
4. Select Xerox Features from the print driver properties menu - the name of the menu will vary
depending on the application you are printing from. From most applications select the
dropdown menu that states Copies and Pages, or that states the application name.
5. Select Paper / Output from the Xerox Features group selection menu. This is usually the active
area when the print driver opens.
6. Select the option required from the Job Type menu.
7. Select the option(s) required.
8. Select the confirmation button, the name will vary depending on the application you are
printing from. From most applications select the OK or Print button.
9. Collect your job from the device.
10. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
11. Print jobs are usually shown in the Active Jobs list, however if your System Administrator has
enabled the Hold All Jobs feature, your job will be listed in either the Held Print Jobs or the
Unidentified Print Jobs list. To release a held job select the job in the required list and then
select the Release button.
12. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Printing a Normal Print Job using the Mac Print Driver
Printing a Secure Print Job using the Mac Print Driver
Printing a Delay Print Job using the Mac Print Driver
Printing a Sample Set Job using the Mac Print Driver
Saving Jobs using the Mac Print Driver
Sending a Fax using the Mac Print Driver
Viewing Active Jobs using the Job Status Menu
Releasing a Held Job using the Job Status Menu
Releasing a Secure Print Job using the Job Status Menu
Accessing Your Personal Secure Jobs List using the Job Status Menu
User Guide
®
WorkCentre XXXX
465