Setting The Output Color For A Single-Touch Scan - Xerox WorkCentre series User Manual

Scan
Lift up the document feeder. Place the first segment face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
6. Select the Build Job button.
7. Select the On button to turn the Build Job feature on and enable the Build Job options.
If required, select the Off button to cancel any programming you have entered.
•
8. If required, select the options for the segment.
9. Press the Start button on the control panel to scan the original.
10. Remove the first segment originals after they have been scanned. The Build Job screen displays
the first segment in the list.
11. Load the second segment originals.
12. Select the features required for the second segment.
13. Press the Start button on the control panel to scan the original.
14. Repeat these steps until all segments of your job have been programmed and scanned.
15. After the last segment has been scanned, select the Submit Job button.
16. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
17. Remove the original from the document feeder or document glass when scanning has
completed.
18. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
More Information
Using a User ID to Log In at the Device
System Administrator Guide www.xerox.com/support.
Using Internet Services to find System Administrator Contact Details

Setting the Output Color for a Single-Touch Scan

The Single-Touch Scan feature is a fast and convenient way to scan a document and send it to a
predefined scan destination on your computer or network location.
Your System Administrator will create a button on the device touch screen for each Single-Touch
Scan destination (up to 10 buttons) and can customize the color scheme, logo and instructional
text that displays when you select the Single-Touch Scan button. Your System Administrator can
also change the name of the Single-Touch Scan button.
The Single-Touch Scan service can be configured with scan settings already specified so that you
can scan your document quickly. Your System Administrator can also customize the service so that
you can select the Build Job, Output Color, Original Type, 2-Sided Scanning and File Name settings
each time you scan your document.
Note: This option must be made available by your System Administrator.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Single-Touch Scan feature.
User Guide
®
WorkCentre XXXX
289