Xerox WorkCentre series User Manual page 112

Copy
7. Select the Output Format tab.
8. Select the Special Pages button.
9. Select the Chapter Starts... button.
10. Select the Page Number entry box and use the numeric keypad to enter the page number of
the original where you want a chapter to start.
11. Select the required option from the Start Chapter section.
• On Right Page starts the new chapter on a right page.
• On Left Page starts the new chapter on a left page.
12. Select the Add button.
13. Repeat the previous three steps as required until all the chapters have been programmed.
14. Select the Close button to save the information you entered.
15. Select the OK button.
16. Enter the number of prints required using the numeric keypad on the control panel.
17. Press the Start button on the control panel to scan the original.
18. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
19. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
20. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Using a User ID to Log In at the Device
Viewing the Progress and Details of a Job using the Job Status Menu
Adding Inserts into Copy Sets
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Use the Inserts option to add blank pages on a different media into your document, or to specify
pages to be printed on a different media. Up to two sources of media can be used for the inserts. If
inserting blank pages, a blank sheet must be inserted in the appropriate place in your original
document.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
112
®
WorkCentre XXXX
User Guide