Xerox WorkCentre series User Manual page 717

General Care and Troubleshooting
• Use Original Size to specify the size of the original.
• Clean the Charge Scorotron and Transfer Corotron, if available on your device.
• Clean the document glass and if using the document feeder also clean the Constant Velocity
Transport Glass (the thin strip of glass to the left of the document glass), especially near the
plastic ramp on the glass.
More Information
Specifying the Size of the Original to be Copied
Cleaning the Document Glass and Both Constant Velocity Transport Glass Strips
Characters are missing from the output
• Load fresh paper.
• Try using a smoother paper.
• Select darken if the original is light or the font is colored.
More Information
Storing Paper and Other Media
Lightening or Darkening Copies
Adjusting the Lightness of your Print using the PostScript Driver
Adjusting the Lightness of your Print using the Mac Print Driver
There are gloss variations (coining)
• Check the quality of the original.
• If the original has large areas of solid density, adjust the contrast.
More Information
Setting the Copy Contrast
There is a double image or show through (ghosting)
• Check the quality of the original.
• Clean the document glass, if it is being used.
• Rotate the original 180 degrees and try the job again.
More Information
Cleaning the Document Glass and Both Constant Velocity Transport Glass Strips
The device cannot sense the size of the original on the glass
• Use Original Size to specify the size of the original.
• Rescan the original, leaving the cover raised.
More Information
Specifying the Size of the Original to be Copied
User Guide
®
WorkCentre XXXX
717