Xerox WorkCentre series User Manual page 280

Scan
Using the Scan To Feature
Erasing Edges from Documents using the Scan To Feature
Use the Scan To... Feature to scan a document and store it in a folder on your computer or network.
To use Scan To you need to create an entry in the Device Address Book which contains the path to
the location that you want to scan to.
The Scan To button is grayed out on the device touch screen if there are no Scan To entries in the
Device Address Book.
Note: This option must be made available by your System Administrator.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Scan To features.
Use the Edge Erase options to specify the scan area so that only a specific section of your document
is scanned. This is useful if you want to remove the marks caused by punched holes or staples in
your original.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Scan To... button on the touch screen.
5. If required, select the Device Address Book button. (Your System Administrator may have set
up the address book to automatically open.)
6. Select the address required.
7. Select the Add To Recipients button.
8. Select the OK button.
9. Select the Layout Adjustment tab.
10. Select the Edge Erase button.
11. Select the Edge Erase option required.
• All Edges erases an equal amount from all the edges. Use the arrow buttons to adjust the
amount to be erased from 3 mm (0.1") to 50 mm (2.0") or select the entry field and use the
numeric keypad to enter the amount required.
• Individual Edges enables a different amount to be erased from each of the edges, on
both the first and second sides. Use the arrow buttons to adjust the amount to be erased
from 3mm (0.1") to 50mm (2.0") or select the appropriate entry field and use the numeric
keypad to enter the amount required.
12. Select the OK button.
13. Press the Start button on the control panel to scan the original.
14. Remove the original from the document feeder or document glass when scanning has
completed.
280
®
WorkCentre XXXX
User Guide