Table of Contents
Advertisement
General Care and Troubleshooting
Loading Tray 4
Loading the Bypass Tray and Changing the Tray Settings
Powering the Device Off
Powering the Device On
Repeated Check Tray messages
•
Adjust the edge guides against the stack of paper in the tray.
•
If the edge guides were not set against the paper in the tray when Start was selected, delete
the job in the job queue and begin again.
•
Check that the touch screen is displaying the correct size and type for the media in use.
If everything appears correct but the problem persists turn the device off, wait 2 minutes and then
switch it back on again.
More Information
Loading Tray 1 and Changing the Tray Settings
Loading Tray 2 and Changing the Tray Settings
Loading Tray 3
Loading Tray 4
Loading the Bypass Tray and Changing the Tray Settings
Repeated paper jams, misfeeds or multi sheet feeds
Paper curls
•
Load the paper in the paper trays with the seam side of the paper up. Load the paper in the
Bypass Tray with the seam side down.
•
Load non-standard media in the Bypass Tray.
•
If the paper curls excessively, flip the paper over in the applicable paper tray.
•
Check media has been stored correctly.
More Information
Storing Paper and Other Media
Loading Tray 1 and Changing the Tray Settings
Loading Tray 2 and Changing the Tray Settings
Loading Tray 3
Loading Tray 4
Loading the Bypass Tray and Changing the Tray Settings
The finisher does not stack the output correctly
•
Unload the finisher tray frequently especially if stacking mixed-size paper.
•
Do not remove stapled sets while the finisher is compiling.
•
Check the paper tray guides are locked into position against the paper.
•
When using large paper, remove any output contained in the Stacker Tray.
•
Load the paper in the paper trays with the seam side of the paper up. Load the paper in the
Bypass Tray with the seam side down.
•
Load non-standard media in the Bypass Tray.
•
If the paper curls excessively, flip the paper over in the applicable paper tray.
User Guide
®
WorkCentre
XXXX
713
Advertisement
Table of Contents
Troubleshooting
